Skip to content
SOLID WORKS ClubSOLID WORKS Club

Exercises

Intermediate SOLIDWORKS exercises

Sixteen parts and three small assemblies for after the basics: sweeps along helices and paths, lofts, revolved and shelled containers, draft, countersinks, patterns and feature order that matters. The assemblies reuse parts from both sets and check the total mass and the centre of mass — just like the CSWA's assembly questions.

Kevin Walsh Kevin Walsh Updated Checked for SOLIDWORKS 2026
Intermediate practice parts including a spring, pulley, bottle, enclosure and a small shaft assembly

Exercise list

# Exercise Type Check mass
1 Pillow block Grey cast iron 655.48 g
2 V-belt pulley Aluminium 6061 193.19 g
3 Clevis Mild carbon steel 336.48 g
4 Lightened wheel Aluminium 6061 350.57 g
5 Enclosure with screw bosses Aluminium 6061 166.92 g
6 Compression spring Mild carbon steel 31.38 g
7 Swept handle Mild carbon steel 112.86 g
8 Lofted hopper Aluminium 6061 51.84 g
9 Bottle Aluminium 6061 107.26 g
10 Fluted knob Aluminium 6061 62.67 g
11 Pipe tee Mild carbon steel 265.16 g
12 Countersunk plate Aluminium 6061 139.31 g
13 Bearing housing Grey cast iron 775.40 g
14 Drafted tray Aluminium 6061 77.85 g
15 Eccentric cam Mild carbon steel 341.81 g
16 Motor mount plate Aluminium 6061 174.81 g
17 Spacer stack assembly Assembly 645.55 g
18 Bracket pair assembly Assembly 741.28 g
19 Shaft in pillow blocks assembly Assembly 1,754.40 g

Sweeps and lofts are taught in Sweep and Loft; mates in the assemblies course. Haven't done the basic exercises yet? Start there — the assemblies reuse three of those parts.

Finished the set? Move on to the projects — real objects such as a bench vise and a gearbox.

The 19 intermediate exercises

Frequently asked questions

What should I know before the intermediate exercises?

+

The basic exercises, plus sweep, loft, shell, draft and Hole Wizard from the features course and standard mates from the assemblies course.

How is the assembly centre of mass measured?

+

Each assembly page states it relative to the base part — for example the height above the plate's bottom face. Mass Properties shows it as X, Y, Z in the assembly coordinate system.

Which materials are used?

+

Aluminium 6061 (2.70 g/cm³), mild carbon steel (7.85 g/cm³), brass C26000 (8.53 g/cm³) and grey cast iron (7.20 g/cm³).