Skip to content
SOLID WORKS ClubSOLID WORKS Club

Intermediate assembly 17

Intermediate exercise 17: Spacer stack assembly

Your first assembly with a check value: the base plate from basic exercise 1 with four brass hex spacers standing on its holes. Check the total mass and the height of the centre of mass.

Kevin Walsh Kevin Walsh Updated Checked for SOLIDWORKS 2026
3D render of the spacer stack assembly from SOLIDWORKS intermediate exercise 17
Level
Intermediate
Time
15 min
Material
Per component (see parts list)
Check mass
645.55 g total

The drawing

Dimensioned drawing of the spacer stack assembly with top, front, right and isometric views
Dimensions in mm, third-angle projection. Download the PDF to print it.

Parts list

Part Qty Material Exercise
Base plate with four holes 1 Aluminium 6061 model it
Hex spacer 4 Brass C26000 model it

What you practise

  • Inserting the first component fixed at the origin
  • Concentric and coincident mates
  • Assembly mass properties with mixed materials

How to approach it

  1. Insert the base plate first, fixed, with its origin at the centre of the bottom face (as modelled in exercise 1).
  2. Insert a hex spacer: Concentric with a plate hole, Coincident bottom face to the plate's top face, one flat parallel to the plate's long edge.
  3. Repeat for all four holes, or pattern the component.

Check your result

Give every part the material from the parts list, then open Evaluate → Mass Properties in the assembly. The total mass should be 645.55 g. The centre of mass is centred on the plate in plan and 17.23 mm above the plate's bottom face. Mass Properties reports the centre of mass in the assembly's coordinate system; with the first part's origin at the base and its bottom face on the Top plane, the height above the base is the Y value. The CSWA asks the same kind of question — see the practice test.

Next: intermediate exercise 18.

Download files

Commands used

Show solution
  1. Insert base-plate (fixed at the origin).
  2. Insert hex-spacer: Concentric (spacer bore, plate hole), Coincident (spacer bottom, plate top), Parallel (one flat, plate long edge).
  3. Linear Component Pattern 2 × 100 and 2 × 60, or three more copies with the same mates.
  4. Mass = 250.72 + 4 × 98.71 = 645.55 g; centre of mass height = (250.72 × 5 + 394.84 × 25) / 645.55 = 17.23 mm.

Frequently asked questions

Why does each part keep its own material?

+

Materials belong to parts. Assembly Mass Properties adds up the parts' masses, so the plate counts as aluminium and the spacers as brass.