Intermediate exercise 11
Intermediate exercise 11: Pipe tee
A steel pipe tee: two Ø30 tubes with Ø24 bores meeting at right angles. The order is the lesson — add both solids, then cut both bores.

- Level
- Intermediate
- Time
- 15 min
- Material
- Mild carbon steel, 7.85 g/cm³
- Check mass
- 265.16 g
The drawing
What you practise
- Two extrudes on different planes
- Bores cut after merging
- Reading an intersection in the views
How to approach it
- Main tube Ø30 × 100 along X, centred.
- Branch Ø30 from the axis, 50 long.
- Then cut Ø24 bores through both.
Check your result
Apply Mild carbon steel or a custom material with 7.85 g/cm³, then open Evaluate → Mass Properties. The mass should be 265.16 g (volume 33,778.35 mm³). Off by 1,000? Check the density units with the mass calculator.
Next: intermediate exercise 12.
Download files
Commands used
Show solution
- Right plane: Ø30 → Extrude Mid Plane 100.
- Front plane: Ø30 → Extrude 50.
- Ø24 → Cut Mid Plane 100; Ø24 → Cut 50 for the branch.
Frequently asked questions
What if I cut the main bore before adding the branch?
+
The branch extrude fills part of the bore again. Add all solids first, then cut.
Related
- Intermediate exercise 12: Countersunk plateIntermediate SOLIDWORKS exercise 12, countersunk plate: hole Wizard countersink. Drawing, STEP file and check mass 139.31 g.
- Intermediate exercise 10: Fluted knobIntermediate SOLIDWORKS exercise 10, fluted knob: cutting one flute and patterning it. Drawing, STEP file and check mass 62.67 g.
- SOLIDWORKS Extruded Boss/BaseHow to use Extruded Boss/Base in SOLIDWORKS: every end condition from Blind to Mid Plane, Direction 2, draft, thin features, Selected Contours and Merge result.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.