Intermediate exercise 13
Intermediate exercise 13: Bearing housing
A cast-iron bearing housing: a flange with three bolt holes, a body, a Ø25 through bore and a Ø35 bearing seat 12 deep at the top.

- Level
- Intermediate
- Time
- 20 min
- Material
- Grey cast iron, 7.20 g/cm³
- Check mass
- 775.40 g
The drawing
What you practise
- Stepped bore: seat plus through hole
- Three holes on a pitch circle
- Revolve or extrude — your choice
How to approach it
- Flange Ø90 × 10, body Ø55 to 40 total.
- Ø25 through; Ø35 × 12 deep from the top.
- Three Ø9 on Ø72, one at the top (90°).
Check your result
Apply Grey cast iron or a custom material with 7.20 g/cm³, then open Evaluate → Mass Properties. The mass should be 775.40 g (volume 107,693.80 mm³). Off by 1,000? Check the density units with the mass calculator.
Next: intermediate exercise 14.
Download files
Commands used
Show solution
- Ø90 → Extrude 10; Ø55 → Extrude 30.
- Ø25 → Cut Through All; Ø35 → Cut 12 from the top.
- Ø9 at (0, 36) → Circular Pattern 3.
Frequently asked questions
What is a bearing seat?
+
A bore sized for the bearing's outer ring; the shoulder at the bottom locates it axially.
Related
- Intermediate exercise 14: Drafted trayIntermediate SOLIDWORKS exercise 14, drafted tray: extrude with draft. Drawing, STEP file and check mass 77.85 g. Free practice.
- Intermediate exercise 12: Countersunk plateIntermediate SOLIDWORKS exercise 12, countersunk plate: hole Wizard countersink. Drawing, STEP file and check mass 139.31 g.
- SOLIDWORKS Extruded Boss/BaseHow to use Extruded Boss/Base in SOLIDWORKS: every end condition from Blind to Mid Plane, Direction 2, draft, thin features, Selected Contours and Merge result.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.