Basic exercise 1
Exercise 1: Base plate with four holes
A flat aluminium plate with a hole in each corner — the classic first part. It practises a centred rectangle, an extrude and a pattern of identical holes, and its mass is the same check value used on our mass calculator page.

- Level
- Basic
- Time
- 10 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 250.72 g
The drawing
What you practise
- Centred rectangle with dimensions from the origin
- Extruded Boss to a fixed thickness
- Four identical through holes placed symmetrically
How to approach it
- Sketch a 120 × 80 centre rectangle on the Top plane so the origin sits in the middle.
- Extrude 10 mm.
- Place one Ø10 hole 10 mm in from two edges, then pattern or mirror it — or use Hole Wizard with four points.
- Apply Aluminium 6061 or a custom material with 2.70 g/cm³.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 250.72 g (volume 92,858.41 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 2.
Download files
Commands used
Show solution
- Centre rectangle 120 × 80 on Top → Extruded Boss 10 mm.
- Sketch on the top face: four Ø10 circles at ±50, ±30 from the origin (use symmetric relations to the origin).
- Extruded Cut → Through All.
- Volume = 120 × 80 × 10 − 4 × π × 5² × 10 = 92,858.41 mm³.
Frequently asked questions
Why use a centre rectangle?
+
With the origin in the middle, the plate and its holes stay symmetric and the sketch is fully defined with only two size dimensions plus the hole positions.
What is the mass of exercise 1?
+
250.72 g in aluminium 6061 at 2.70 g/cm³ — a volume of 92,858.41 mm³.
Related
- Exercise 2: Chamfered bushingSOLIDWORKS practice exercise 2, chamfered bushing: two concentric circles in one sketch. Dimensioned drawing, STEP file and a check mass of 171.79 g.
- Basic SOLIDWORKS exercises18 basic SOLIDWORKS exercises for beginners: plates, shafts, flanges, brackets and shelled parts, each with a drawing, STEP file and check mass.
- SOLIDWORKS rectangle toolsHow to sketch rectangles in SOLIDWORKS: Corner, Center, 3 Point Corner, 3 Point Center and Parallelogram, with construction lines and centring.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.