Basic exercise 4
Exercise 4: Hub flange
An aluminium flange with a raised hub, a bore and six bolt holes on a pitch circle. It combines two extrudes with a through hole and a circular pattern.

- Level
- Basic
- Time
- 20 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 439.57 g
The drawing
What you practise
- Extruding a second feature from a face
- Bore through both features
- Circular pattern of holes on a pitch circle diameter
How to approach it
- Disk Ø120 × 12, then a Ø60 hub on top so the total height is 32.
- Cut a Ø30 bore through everything.
- One Ø11 hole on a Ø90 construction circle, then a circular pattern of 6.
- Material: aluminium 6061, 2.70 g/cm³.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 439.57 g (volume 162,803.61 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 5.
Download files
Commands used
Show solution
- Ø120 circle → Extrude 12. Ø60 on the top face → Extrude 20.
- Ø30 → Cut Through All.
- Ø11 at 45 mm from the centre → Cut Through All → Circular Pattern, 6 equal instances.
- Volume = π(60² × 12 + 30² × 20 − 15² × 32 − 6 × 5.5² × 12) = 162,803.61 mm³.
Frequently asked questions
What does PCD mean?
+
Pitch circle diameter — the diameter of the circle the hole centres sit on, here Ø90.
What is the mass of exercise 4?
+
439.57 g in aluminium 6061 at 2.70 g/cm³ — a volume of 162,803.61 mm³.
Related
- Exercise 5: Angle bracketSOLIDWORKS practice exercise 5, angle bracket: l-shaped closed profile on the Front plane. Dimensioned drawing, STEP file and a check mass of 245.28 g.
- Exercise 3: Stepped shaftSOLIDWORKS practice exercise 3, stepped shaft: revolving a half-profile about a centreline. Dimensioned drawing, STEP file and a check mass of 443.43 g.
- SOLIDWORKS Extruded Boss/BaseHow to use Extruded Boss/Base in SOLIDWORKS: every end condition from Blind to Mid Plane, Direction 2, draft, thin features, Selected Contours and Merge result.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.