Basic exercise 2
Exercise 2: Chamfered bushing
A brass bushing — a tube with chamfered outer edges. It is the simplest revolved or extruded round part and a good first use of Chamfer on circular edges.

- Level
- Basic
- Time
- 10 min
- Material
- Brass C26000, 8.53 g/cm³
- Check mass
- 171.79 g
The drawing
What you practise
- Two concentric circles in one sketch
- Extruding a ring profile
- Chamfer on selected circular edges only
How to approach it
- Sketch Ø30 and Ø16 concentric circles on the Top plane.
- Extrude 40 mm — the ring profile gives the hole at once.
- Chamfer 1 × 45° on the two outer circular edges only; the bore edges stay sharp.
- Material: brass, 8.53 g/cm³.
Check your result
Apply the material — Brass C26000 — or a custom material with a density of 8.53 g/cm³, then open Evaluate → Mass Properties. The mass should be 171.79 g (volume 20,139.70 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 3.
Download files
Commands used
Show solution
- Circles Ø30 and Ø16 at the origin → Extruded Boss 40 mm.
- Chamfer, Distance–Distance 1 mm, select the outer edge at each end.
- Alternative: revolve a rectangle 7 × 40 placed 8 mm from the axis, then chamfer.
Frequently asked questions
Extrude or revolve?
+
Both work. Extruding two circles is faster; revolving a profile is more flexible when the section has steps or grooves.
What is the mass of exercise 2?
+
171.79 g in brass c26000 at 8.53 g/cm³ — a volume of 20,139.70 mm³.
Related
- Exercise 3: Stepped shaftSOLIDWORKS practice exercise 3, stepped shaft: revolving a half-profile about a centreline. Dimensioned drawing, STEP file and a check mass of 443.43 g.
- Exercise 1: Base plate with four holesSOLIDWORKS exercise 1, base plate with four holes: centred rectangle with dimensions from the origin. Drawing, STEP file and check mass 250.72 g.
- SOLIDWORKS circle toolsHow to sketch circles in SOLIDWORKS with the Circle and Perimeter Circle tools, dimension the diameter, add Equal relations and measure to the edge.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.