Basic exercise 17
Exercise 17: Wedge block
A steel wedge with a sloped top, 30 mm high at one end and 15 mm at the other. One sketch, one extrude — but the drawing has no angle dimension, so read the heights.

- Level
- Basic
- Time
- 5 min
- Material
- Mild carbon steel, 7.85 g/cm³
- Check mass
- 423.90 g
The drawing
What you practise
- Four-line profile with a sloped line
- Dimensioning by heights instead of angle
- Extruding to a depth
How to approach it
- Front plane: 60 long, 30 high on the left, 15 on the right.
- Extrude 40.
- The slope angle is atan(15 / 60) = 14.04°.
Check your result
Apply the material — Mild carbon steel — or a custom material with a density of 7.85 g/cm³, then open Evaluate → Mass Properties. The mass should be 423.90 g (volume 54,000.00 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 18.
Download files
Commands used
Show solution
- Profile (0,0)–(60,0)–(60,15)–(0,30) → Extrude 40.
- Volume = (30 + 15) / 2 × 60 × 40 = 54,000 mm³.
Frequently asked questions
Could I cut the slope instead?
+
Yes: extrude a 60 × 30 × 40 block and cut the triangle away. The profile method needs fewer features.
What is the mass of exercise 17?
+
423.90 g in mild carbon steel at 7.85 g/cm³ — a volume of 54,000.00 mm³.
Related
- Exercise 18: Disk with hole patternSOLIDWORKS practice exercise 18, disk with hole pattern: circular pattern with equal spacing. Dimensioned drawing, STEP file and a check mass of 174.37 g.
- Exercise 16: Link armSOLIDWORKS practice exercise 16, link arm: straight Slot as an outer profile. Dimensioned drawing, STEP file and a check mass of 95.67 g.
- SOLIDWORKS Line toolHow to draw lines in SOLIDWORKS: the Line, Centerline and Midpoint Line tools, chain drawing, switching to a tangent arc, orientation options and L.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.