Basic exercise 8
Exercise 8: Shelled cup
A thin-walled aluminium cup made with one command. A solid cylinder becomes a cup when Shell removes the top face and leaves 2 mm walls.

- Level
- Basic
- Time
- 5 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 37.90 g
The drawing
What you practise
- Shell with a removed face
- Wall thickness inside the outer size
- Checking mass of a thin-walled part
How to approach it
- Cylinder Ø60 × 25.
- Shell 2 mm, select the top face to remove.
- Outer size stays 60 × 25; walls and base are 2 mm.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 37.90 g (volume 14,036.64 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 9.
Download files
Commands used
Show solution
- Ø60 → Extrude 25.
- Shell, thickness 2, faces to remove: top face.
- Volume = π × 30² × 25 − π × 28² × 23 = 14,036.64 mm³.
Frequently asked questions
Does Shell keep the outside size?
+
Yes, by default the material goes inward. Shell outward adds it outside instead.
What is the mass of exercise 8?
+
37.90 g in aluminium 6061 at 2.70 g/cm³ — a volume of 14,036.64 mm³.
Related
- Exercise 9: Open boxSOLIDWORKS practice exercise 9, open box: shell on a rectangular block. Dimensioned drawing, STEP file and a check mass of 140.91 g.
- Exercise 7: Hex spacerSOLIDWORKS practice exercise 7, hex spacer: polygon tool with six sides. Dimensioned drawing, STEP file and a check mass of 98.71 g.
- SOLIDWORKS circle toolsHow to sketch circles in SOLIDWORKS with the Circle and Perimeter Circle tools, dimension the diameter, add Equal relations and measure to the edge.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.