Basic exercise 9
Exercise 9: Open box
An open aluminium box 100 × 60 × 40 with 3 mm walls — the starting point of every enclosure. One extrude and one shell.

- Level
- Basic
- Time
- 5 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 140.91 g
The drawing
What you practise
- Shell on a rectangular block
- Open face selection
- Wall thickness and inside dimensions
How to approach it
- Block 100 × 60 × 40.
- Shell 3 mm with the top face removed.
- Inside size: 94 × 54 × 37.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 140.91 g (volume 52,188.00 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 10.
Download files
Commands used
Show solution
- Centre rectangle 100 × 60 → Extrude 40.
- Shell 3 mm, remove the top face.
- Volume = 100 × 60 × 40 − 94 × 54 × 37 = 52,188 mm³.
Frequently asked questions
How would I add a lid lip?
+
Offset the top edges inward in a sketch on the rim and extrude a thin wall — the intermediate exercises cover it.
What is the mass of exercise 9?
+
140.91 g in aluminium 6061 at 2.70 g/cm³ — a volume of 52,188.00 mm³.
Related
- Exercise 10: Ribbed bracketSOLIDWORKS practice exercise 10, ribbed bracket: building a part from two extrudes. Dimensioned drawing, STEP file and a check mass of 492.35 g.
- Exercise 8: Shelled cupSOLIDWORKS practice exercise 8, shelled cup: shell with a removed face. Dimensioned drawing, STEP file and a check mass of 37.90 g.
- SOLIDWORKS rectangle toolsHow to sketch rectangles in SOLIDWORKS: Corner, Center, 3 Point Corner, 3 Point Center and Parallelogram, with construction lines and centring.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.