Basic exercise 15
Exercise 15: Grooved pin
A small steel pin with a retaining-ring groove and chamfered ends — modelled the way a lathe would make it, as one revolve plus small details.

- Level
- Basic
- Time
- 10 min
- Material
- Mild carbon steel, 7.85 g/cm³
- Check mass
- 30.43 g
The drawing
What you practise
- Revolve with a groove in the profile
- Small dimensions and chamfers
- Checking a light part's mass
How to approach it
- Ø10 × 50 pin.
- Groove 1.5 wide to Ø8, starting 6 mm from one end.
- Chamfer 0.5 on both ends.
Check your result
Apply the material — Mild carbon steel — or a custom material with a density of 7.85 g/cm³, then open Evaluate → Mass Properties. The mass should be 30.43 g (volume 3,876.99 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 16.
Download files
Commands used
Show solution
- Revolve a half-profile including the groove step, or extrude Ø10 × 50 and cut a revolved groove.
- Chamfer 0.5 on both end edges.
- Groove removes π × (5² − 4²) × 1.5 = 42.41 mm³.
Frequently asked questions
What is the groove for?
+
A retaining ring (circlip) sits in it to hold the pin in place axially.
What is the mass of exercise 15?
+
30.43 g in mild carbon steel at 7.85 g/cm³ — a volume of 3,876.99 mm³.
Related
- Exercise 16: Link armSOLIDWORKS practice exercise 16, link arm: straight Slot as an outer profile. Dimensioned drawing, STEP file and a check mass of 95.67 g.
- Exercise 14: T-barSOLIDWORKS practice exercise 14, t-bar: symmetric profile about a centreline. Dimensioned drawing, STEP file and a check mass of 217.73 g.
- SOLIDWORKS RevolveHow to use Revolved Boss/Base and Revolved Cut in SOLIDWORKS: sketch half a profile, choose the axis, set the angle and fix open-sketch errors.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.