Basic exercise 11
Exercise 11: U-channel
An aluminium U-channel, 150 mm long. A good exercise in drawing a closed profile with the Line tool and extruding it — or using a thin feature.

- Level
- Basic
- Time
- 5 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 263.25 g
The drawing
What you practise
- Closed profile from lines
- Equal and symmetric relations
- Extruding a profile as a long section
How to approach it
- Right plane: U 60 wide, 40 high, walls and base 5 thick.
- Use symmetric relations about the vertical centreline.
- Extrude 150 mm.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 263.25 g (volume 97,500.00 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 12.
Download files
Commands used
Show solution
- Profile with 8 lines; symmetric about a vertical centreline.
- Extrude 150.
- Section area = 60 × 40 − 50 × 35 = 650 mm² → volume 97,500 mm³.
Frequently asked questions
Could I use a thin feature?
+
Yes: draw only the U centre-line or outline as an open sketch and extrude it as a thin feature 5 mm thick.
What is the mass of exercise 11?
+
263.25 g in aluminium 6061 at 2.70 g/cm³ — a volume of 97,500.00 mm³.
Related
- Exercise 12: Hub with keywaySOLIDWORKS practice exercise 12, hub with keyway: bore through a disk. Dimensioned drawing, STEP file and a check mass of 552.80 g.
- Exercise 10: Ribbed bracketSOLIDWORKS practice exercise 10, ribbed bracket: building a part from two extrudes. Dimensioned drawing, STEP file and a check mass of 492.35 g.
- SOLIDWORKS Line toolHow to draw lines in SOLIDWORKS: the Line, Centerline and Midpoint Line tools, chain drawing, switching to a tangent arc, orientation options and L.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.