Basic exercise 13
Exercise 13: Counterbored block
An aluminium block with two counterbored holes for M10 socket-head screws. The Hole Wizard builds the counterbore from one point per hole.

- Level
- Basic
- Time
- 10 min
- Material
- Aluminium 6061, 2.70 g/cm³
- Check mass
- 234.33 g
The drawing
What you practise
- Hole Wizard counterbore type
- Custom counterbore sizes
- Placing holes on a face with sketch points
How to approach it
- Block 80 × 40 × 30.
- Hole Wizard, counterbore: Ø11 thru, counterbore Ø18 × 11 deep.
- Two positions 50 apart on the centre line of the top face.
Check your result
Apply the material — Aluminium 6061 — or a custom material with a density of 2.70 g/cm³, then open Evaluate → Mass Properties. The mass should be 234.33 g (volume 86,790.42 mm³). If you are out by a factor of 1,000, the density units are wrong; check them with the mass calculator. Mass properties are explained in the mass properties lesson.
Next: exercise 14.
Download files
Commands used
Show solution
- Centre rectangle 80 × 40 → Extrude 30.
- Hole Wizard → Counterbore, custom size: Ø11 through, Ø18 × 11 counterbore.
- Positions at x = ±25 on the top face.
- Each hole removes π × 5.5² × 30 + π × (9² − 5.5²) × 11 = 4,604.79 mm³.
Frequently asked questions
Why not cut two circles?
+
Hole Wizard stores the hole type, so drawings get the full callout and CAM recognises it.
What is the mass of exercise 13?
+
234.33 g in aluminium 6061 at 2.70 g/cm³ — a volume of 86,790.42 mm³.
Related
- Exercise 14: T-barSOLIDWORKS practice exercise 14, t-bar: symmetric profile about a centreline. Dimensioned drawing, STEP file and a check mass of 217.73 g.
- Exercise 12: Hub with keywaySOLIDWORKS practice exercise 12, hub with keyway: bore through a disk. Dimensioned drawing, STEP file and a check mass of 552.80 g.
- SOLIDWORKS Hole WizardHow to use the SOLIDWORKS Hole Wizard: hole types, standards, sizes and fit, the Type and Positions tabs, cosmetic threads, slots, favourites and Advanced Hole.
- Mass calculator for SOLIDWORKS and CSWA problemsCalculate part mass from volume and density in mm, cm, m or inches, with typical densities for steel, aluminium, brass and copper. Built for CSWA checks.